1. Open the lid. According to the instructions, lift the safety pin, turn the handwheel, and open the lid of the horizontal steam sterilizer in china.

2. Power up. Turn on the power supply consistent with the sterilizer label, turn the power switch of the control panel to ON, the panel low water level light will be on, the equipment will alarm, indicating that there is no water in the pot.

3. Add water. Close the steam exhaust valve, and inject purified water into the sterilizer. When the high water level light is on, the equipment stops alarming. Observe the sterilization chamber of the sterilizer. water volume.

4. To stack. Put the wrapped sterilized items into the sterilizer sterilization chamber, leave a gap for placing the items, and put them into the sterilization chamber in sequence, which is conducive to the penetration of steam. steam, to prevent the failure of pressure relief due to the blockage of the steam release valve, resulting in the explosion accident of the boiler body.

5. Seal. Put the lid down, turn the handwheel to the end as instructed, until it can't turn. At this time, the sealing switch is on, and the lid is closed.

6. Set the temperature and time. When sterilizing the medium, different sterilization time and temperature should be set according to the characteristics of the medium. It should be noted that the sterilization temperature and time of different mediums are different and cannot be sterilized together.

7. Sterilization. When the temperature and time are set, click the "start button" to sterilize, and the sterilizer is locked at this time. After the sterilization is over, the sterilizer alarms, and the sterilizer is turned off at this time.

8. Dry. After the sterilization is over, the solid material can manually open the steam exhaust valve, release the pressure, cool the temperature, open the pot, and take out the sterilized material; the liquid material is strictly prohibited to manually exhaust the steam to reduce the pressure and reduce the temperature, and can only be taken out after the sterilizer is naturally depressurized and cooled. , to prevent the liquid from bumping and splashing.

9. Open the lid. Lift the safety pin, open the lid of the horizontal steam sterilizer in china, and take out the sterilized material. It should be noted that when the cover is opened, the temperature in the equipment sterilization room is high and the steam is sufficient to prevent burns from the high-temperature pot and steam; when taking materials, wear anti-scalding gloves to prevent high-temperature burns, and to prevent stress reactions from contaminating or breaking the materials.