Table top steam sterilizer is a very commonly used sterilization equipment. It is often used in hospitals, biology, medicine, scientific research and other units. It is mainly used for high-temperature disinfection and sterilization of utensils and utensils. table top steam sterilizer has the characteristics of easy to use, simple operation, safety, low power consumption, etc., so it is widely used, but in order to use it well, you have to master the use methods and precautions. Let's briefly introduce the use. table top steam sterilizer to pay attention to some issues.

1. Warm up, check whether there is a certain amount of water in the table top steam sterilizer before warming up. This is very important. Check whether the utensils to be sterilized are wrapped with kraft paper, and whether they are placed up along the bottle mouth. Check Whether the sterilization cover is covered properly, especially to check whether the gasket is aligned with the circular groove, if the gasket is not aligned, there will be steam leakage, which is difficult to achieve sterilization effect, and it is not safe; check whether the vent hole is open , Generally, when the temperature rises to 90 degrees, close the vent and continue to heat up.

2. Heat preservation, the process of heat preservation is sterilization. At this time, it should be noted that the temperature should not be too high or lower than the specified value, generally between 120-122 degrees, and keep warm for half an hour. Due to the high temperature of the table top steam sterilizer during the heat preservation process, you must wear gloves when operating to avoid burns, and you cannot stay away from it. Be sure to stare at the pointer parameters and watch the time. The heat preservation process can maintain a constant temperature by adjusting the heating switch and adjusting the exhaust gas.

3. Cool down. When the holding time is up, it will start to cool down. Generally, to cool down the table top steam sterilizer can be turned off directly, but the sterilization cover cannot be opened directly. Below the temperature, if you are in a hurry, you can use the method of rapid cooling, that is, open the air vent slightly, and then apply a wet towel on the cover.