The pressure steam sterilizer in china adopts a double-layer structure with self-contained steam. The door body adopts a self-sealing seal, which is simple and reliable in structure and easy to operate. , easy to clean.

The principle of pressure steam sterilizer in china is that the hot water tank heats and stores hot water, which is convenient for the recycling of multiple devices. When one device is running, the two devices can be placed on a plate, sterilized in the pot, and the product is sterilized after loading , when the three sterilizers are finished sterilizing the product, the hot water of one equipment has been recovered, which is convenient for the use of hot water for the three sterilizers, and enough hot water is used to facilitate the recycling of multiple sterilizers, reducing excessive hot water, At the same time, energy is also reduced. The same is true for heating, and the same is true for cooling. The cooling water directly enters the pot, and the soaking cycle cools down. The use of cooling water alternately reduces the water storage capacity of the cooling pool.

Turn the hand wheel to the left for several times until it reaches the top, so that the lid is fully lifted, pull up the safety latch on the left column, push the beam sideways, insert the plug, and press the power switch on the control panel to ON. At this time, the undervoltage buzzer sounds.

Pressure steam sterilizer in china There should be a certain gap between each package. Do not block the sterilizer package on the air release hole of the safety valve. Add about 8 liters of distilled water until the high water level is bright. If too much water overflows into the inner tank, The lower valve should be opened to prevent the water in the inner tank from being removed.