When laying, the side with the tubular air cushion should be placed upward, otherwise it will affect the control effect. When laying an anti-bedsore mattress, you need to place the air inlet under your feet to reduce the impact of airflow noise.

When you put the anti-bedsore mattress on the bed, you need to put a layer of air cushion on the wire bed to prevent the air cushion from being worn by the spring bed.

While preparing for inflation, it should remain flat. Generally, the first charging time should be controlled within 30 minutes. When inflating, double check the pressure of the air pump. The pressure of the air pump needs to be adjusted to the maximum for the first time, and can be adjusted to the middle after full.

Be sure to add a breathable cotton blanket to the surface of the anti-bedsore mattress. The thickness of the cotton blanket can be effectively determined according to the climate, and straw mats can be placed directly in summer.

The U-shaped air cushion should also be inflated with an air pump to keep the connection between the air nozzle and the inflation tube. Open the carton package of the inflatable rod, and tightly connect the vent pipe joint to the outlet nozzle to ensure that the pipe is not bent. The anti-bedsore mattress can be placed directly on the bed and can be covered with a single layer, but only for a single use.